natural sunlight will glow through the etch designs illuminating every detail.
Light House
Decorative
- Spray the glass liberally with a soapy water solution before applying your window decoration. A
sufficient amount of moisture is required between the decoration and glass to give an even
appearance once dried. - Peel the window decoration from the paper backing and position it on the surface of the glass. Use
your hands to smooth out any large bubbles. It is necessary to place the side of the decoration
that is on the backing paper to the glass. If the patterns are to face each other, apply one to the
interior and one to the exterior of the surface. - NEVER INSTALL ON A DRY SURFACE. For easier handling, spray the surface of the window
decoration after removing it from the paper backing and before applying. This will prevent the film
from cling to itself. - Spray the surface of the window decoration with a soapy water solution. Using a soft, rubber tipped
squeegee, squeegee out the excess air and moisture. DO NOT USE A HARD, PLASTIC TIPPED
SQUEEGEE, AS IT MAY SCRATCH THE SURFACE OF THE WINDOW DECORATION. - Wipe dry with a lint free cloth. If bubbles appear between the window decoration and the surface,
repeat Step 4. Any excess moisture should begin to evaporate within 24 hours.
- Follow steps 1-5 above. The outer surface of the film is a matte finish and the underside of the film
is a glossy finish. Make sure that the glossy side of the film is placed on the surface of the glass.
Position the film as desired and use your hands to smooth out any large bubbles. - After you have squeegeed out the excess air and moisture, use a ruler or straight edge to trim any
excess film. It is recommended that you leave 1/16” space around the perimeter of the window;
making sure that the film does not touch any part of the window frame for the film to adhere
properly to the surface. During the first 12 hours after installation, the film should not be disturbed. - It is recommended that you wait 30 minutes before trimming to avoid movement of the film that can
leave a jagged edge.
Before applying the film to glass, the clear cellophane backing must be removed from the material.
Follow the directions below to remove the cellophane backing
- Go to the corner of the film and attach a piece of tape to the finished (embossed) side. Allow
about one inch of the tape to extend over the edge of the film. - Repeat step 1 on the same corner of the back (cellophane) side of the film.
- Allow the tape to stick to itself by approximately one inch past the edge of the film. Press the tape
together tightly. - Slowly pull the two pieces of tape apart from each other. The clear cellophane should adhere to
the piece of tape for removal. - Follow the applications instructions indicate above to complete your installation.
- If at any time bubbles do occur, simply peel back the area affected and re-apply. Bubbles that
are visible only from the glass side are due to insufficient moisture during application; spray a
generous amount of soapy water solution to fully saturate the glass and material before squeegee. - It is recommend that you save the paper and/or packing for removal and storage.
- Clean and maintain your window film with any household window cleaner and a lint free cloth.
Our no hassle return policy is that any Static Cling item that we sell can be returned minus a 25% restocking
fee (excluding shipping charges) up to 15 days from the date of shipment. In order for a return to be
accepted, the return item must be in its original condition (no damage) and returned in it's original packaging.
Product must be in new condition. No return or exchange on merchandise that shows signs of having been
installed, scratched, or defaced will be allowed. Customers is responsible for all return shipping charges.
Original shipping and handling charges are not refundable.
Hours: 8:30 a.m. to 5:00 p.m. Monday – Friday
All orders shipped UPS FOB Kansas City, Missouri
PRICE SUBJECT TO CHANGE WITHOUT NOTICE.